Motor Stator Stacking Service Applies Blue Epoxy Coating

A motor stator stacking service that maintains precise lamination alignment and applies a consistent thin blue epoxy coating for electrical insulation is available from Applied Plastics Co., Inc. of Norwood, Massachusetts.

Applied Plastics’ Stacking and Coating Service precisely holds lamination alignment to within ±0.0005” and includes deburring and the application of blue epoxy coating from 0.002” to 0.005” thick in one pass.  Ideally suited for laminations from 3/8” to 8” O.D., the finished parts can be wound tighter and their smoothness helps prevent wire cuts and shorts.

Especially developed for motors, stators, and gyroscopes, Applied Plastics’ Stacking and Coating Service produces parts with electrical resistance up to 1,000 V/mil.  Typical metal laminations, bobbins, and end caps can be made from Arnon 7 high carbon steel or Magnesil and the coatings offered include epoxy, PTFE Teflon®, Heresite®, and nylon.

Applied Plastics’ Stacking and Coating Service is priced according to part configuration, coating, and quantity; providing one completed part and SKU. Literature and price quotations are available upon request.
For more information contact:

Applied Plastics LLC
25 Endicott St. / P.O. Box 128
Norwood, MA 02062-0128
(781) 762-1881
[email protected]

Posted in

Superior medical devices require superior coatings.

Our proprietary PTFE Natural® coated mandrels offer unmatched benefits.


Low Coefficient of Friction

PTFE Natural® coatings provide a coefficient of friction generally in the range of 0.05 to 0.20, depending on the load and sliding speed.



PTFE Natural® coatings can operate continuously at temperatures up to 550°F and can be used for intermittent service up to 600°F with adequate ventilation.



Non-Stick Very few solid substances will permanently adhere to a PTFE Natural® coating. While tacky materials may show some adhesion, almost all substances release easily.



Chemical environments usually do not affect a PTFE Natural® coating. Only molten alkali metals and highly reactive fluorinating agents are known to affect this coating.



The proprietary PTFE Natural™ coating process enhances the substrate bonding surface to provide optimum lubricity without flaking or cracking.



Since PTFE Natural® finishes are both hydrophobic and oleophobic, cleanup is easier and more thorough.